The Polar RC3 GPS training computer has an internal, rechargable battery. Use the USB cable included in the product set to charge the training computer via the USB connector on your computer. If you want to plug the USB connector to a wall outlet, use a USB power adapter (not included in the product set).
|
When you plug the micro USB connector into the USB port of the training computer, be careful not to scratch the sealing surfaces of the back case. If sealing surface has deep scratches, it will cause loss of IPx7 grade waterproof level.
After each time of using the USB port of the training computer, check visually that there is no hair, dust or other dirt on the sealing surface area of the lid/back case. Gently wipe to remove any dirt. Do not use any sharp tools or equipment for cleaning, which could cause which can cause scratches to the plastic parts.
↑ Back to topIn continuous use | When recording a training session on average 1h/day, 7 days/week | When only time view is used |
---|---|---|
with the GPS function ON: up to 12 hours | with the GPS function ON: 11 days | 4 months |
with the GPS function OFF: up to 1700 hours | with the GPS function OFF: 120 days |
Battery operating time depends on many factors, such as the temperature of the environment in which you use your training computer, the features you select and use, and battery aging. The operating time is significantly reduced in temperatures well below freezing. Wearing the training computer under your overcoat helps to keep it warmer and to increase the operating time.
You can increase the battery operating time significantly by using Available Accessories instead of the GPS function for measuring speed and distance when you do not need route information.
The battery icon in the upper right hand corner of the display shows the battery charging status and approximately how much charge is left in the battery.
Battery icon | Charge left |
---|---|
80 - 100% | |
60 - 80% | |
40 - 60% | |
20 - 40% | |
8 - 20% | |
The training computer has enough charge for one hour of training with the GPS function on. | |
The remaining charge in the battery icon is blinking. The training computer charge is too low for recording a new training session with the GPS function on. At this point, the training computer switches the GPS function off. The training computer sounds and backlight are also automatically deactivated. A new training recording cannot be started before charging the training computer. |
When the charge is getting low, the training computer notifies you with a message and an alarm.
Low battery notification | Battery status |
---|---|
Battery low This notification is displayed when the training computer has enough charge for one hour of training with the GPS function on. | |
Battery low, GPS off This notification is only displayed in training mode. The training computer charge is too low for continuing the recording of the training session with the GPS function on. At this point, the training computer switches the GPS function off. You can still use Available Accessories and carry out the training session. The training computer sounds and backlight are automatically deactivated. A new training recording cannot be started before charging the training computer. | |
Charge before training The charge is too low for recording a training session. A new training recording cannot be started before charging the training computer. | |
Recording stopped, Battery Empty The charge is critically low. The training computer stops recording the training session, saves the training data and then goes to sleep mode. | |
When the training computer display is blank, the battery is empty and the training computer has gone to sleep mode. Charge the training computer. If the battery is totally drained, it may take a while for the charging animation to appear on the display. |