Which third-party power sensors are compatible with Polar M460?
The compatibility table below shows which third-party power sensors you can use with your M460, and which of their metrics are supported.
- The metrics marked with (X) are supported by your M460.
- The metrics marked with (-) are not supported by your M460.
- The metrics marked with (est.) are provided with an estimated value.
- The metrics marked with (opt) are optional estimations provided by the sensor, supported by M460.
- The metrics marked with a blank space are not available in the sensor.
We have tested the compatibility of M460 with third-party power sensors in close co-operation with the sensor manufacturers.
Please make sure that you use the latest firmware both in your M460 and in the third-party power sensor.
Sensor | Power | Cadence | Speed | Balance | Vector | Min/Max Force | Dead Spots Angles | Offset calibration |
---|---|---|---|---|---|---|---|---|
Favero Assioma | X | X | Â | X | Â | Â | Â | X*** |
Powertap C1 | X | X | Â | (est.) | Â | Â | Â | X |
Powertap G3* | X | (est.) | X | Â | Â | Â | Â | X |
Powertap P1 | X | X | Â | X | - | Â | Â | X |
Powertap P1S | X | X | Â | Â | Â | Â | Â | X |
Stages cycling | X | X | Â | Â | Â | Â | Â | X |
Rotor 2INpower | X | X | Â | X | - | - | - | X |
Quarq DZero | X | X | Â | (est.) | - | Â | Â | X |
Quarq DFour | X | X | Â | (est.) | - | Â | Â | X |
Power2Max NG | X | X | Â | (est.) | - | Â | Â | X |
Power2Max NG Eco | X | X | Â | (opt) | Â | Â | Â | X |
Polar LOOK Kéo Power | X | X |  | X | - | X | X | X |
* Powertap G3: Bluetooth only and Dual models are supported, ANT+ only model is not supported.
** Stages: M460 is compatible with Stages Gen 1 and Gen 2 Power meter from version 2.0.76 onwards. SW update done (v.2.0.78), check Stages update page. M460 is not compatible with Stages Gen 3.
***Favero Assioma: Before doing the calibration, pedal a few rotations after your Polar device has found the sensor signal.