Menu

Which third-party party power sensors are compatible with my V650?

The compatibility table below shows which third-party power sensors you can use with your V650, and which of their metrics are supported.

  • The metrics marked with (X) are supported by your V650.
  • The metrics marked with (-) are not supported by your V650.
  • The metrics marked with (est.) are provided with an estimated value.
  • The metrics marked with (opt) are optional estimations provided by the sensor, supported by V650.
  • The metrics marked with a blank space are not available in the sensor.

We have tested the compatibility of V650 with third-party power sensors in close co-operation with the sensor manufacturers.

Please make sure that you use the latest firmware both in your V650 and in the third-party power sensor.

Sensor Power Cadence Speed Balance Vector Min/Max Force Dead Spots Angles Offset Calibration
Favero Assioma X X   X       X
Powertap C1 X X   (est.)       X
Powertap G3* X (est.) X         X
Powertap P1 X X   X -     X
Powertap P1S X X           X
Stages cycling** (single-side) X X           X
Rotor 2INpower X X   X - - - X
Quarq DZero X X   (est.) -     X
Quarq DFour X X   (est.) -     X
Power2Max NG X X   (est.)       X
Power2Max NG Eco X X   (opt)       X
Polar LOOK Kéo Power X X   X - X X X

 

* PowertapG3: Bluetooth only and Dual models are supported, ANT+ only model is not supported.

** Stages: V650 is compatible with Stages Gen 1 and Gen 2 Power meter from version 2.0.76 onwards. SW update done (v.2.0.78), check Stages update page. V650 is not compatible with Stages Gen 3.

Contact Us
Contact Us
Request repair
Request repair

Change region

If your country is not listed on this page, please find your local contact details, retailers and stores and service points on our global site.