Sport Profile Settings

Adjust the sport profile settings to best suit your training needs. In V800 you can edit certain sport profiles settings in Settings > Sport profiles. You can, for example, set the GPS on or off in different sports.

A wider range of customization options is available in the Flow web service. For more information, See "Sport Profiles"

There are seven sport profiles shown in the pre-training mode by default. In the Flow web service you can add new sports to your list, and sync them to your V800. You can have a maximum of 20 sports on your V800 at a time. The number of sport profiles in the Flow web service is not limited.

By default, in the Sport profiles you'll find:

• Running
• Cycling
• Swimming
• Other outdoor
• Other indoor
• Triathlon
• Free multisport

If you have edited your sport profiles in the Flow web service before your first training session,and synced them to your V800, the sport profile list will contain the edited sport profiles.

Settings

To view or modify sport profile settings, go to Settings > Sport profiles and choose the profile you want to edit. You can also access sport profile settings from pre-training mode by pressing and holding LIGHT. In sport profiles, that include multiple sports (e.g. triathlon and biathlon) the settings for each sport can be modified. For example, in triathlon you can modify the settings for swimming, cycling and running.

• Training sounds: Choose Off, Soft, Loud or Very loud.
• Vibration feedback: Choose On or Off. When set on, V800 vibrates, for example, when you start or stop a training session, GPS signal is found or you reach a training target.
• Heart rate settings: Heart rate view: Choose Beats per minute (bpm), % of maximum or % of Hr reserve. Check HR zone limits: Check the limits for each heart rate zone. HR visible to other device: Choose On or Off. If you choose On, other compatible devices (e.g. gym equipment) can detect your heart rate.
• GPS recording: Choose Off, Normal or Power save, long session.
• Calibrate stride sensor: Choose Automatic or Manual. If you choose Manual, you need to set the calibration factor. Choose Set factor, and enter the factor. For more information on calibration, See "Polar Stride Sensor Bluetooth® Smart"

Stride sensor calibration is visible only if a stride sensor has been paired.

• Calibrate altitude:Set the correct altitude. It is recommended to always manually calibrate altitude when you know your current altitude.

Altitude calibration is only visible when accessing sport profile settings from pre-training mode.

• Speed View: Choose km/h (kilometers per hour) or min/km(minutes per kilometer). If you have chosen imperial units, choose mph (miles per hour) or min/mi (minutes per mile).
• Automatic pause: Choose On or Off. If you set the automatic pause On, your session is automatically paused when you stop moving.

GPS recording must be set to normal to use automatic pause.

• Automatic lap: Choose Off, Lap distance, Lap duration or Location- based. If you choose Lap distance, set the distance after which each lap is taken. If you choose Lap duration, set the duration after each lap is taken. If you choose Location- based, a lap will always be taken at a specific location. (the starting point of your session or POI you have marked during your session)

GPS recording must be set to normal to use automatic lap.